Potential application of a semi-quantitative method for mercury determination in soils, sediments and gold mining residues.

An alternative, low cost method for analyzing mercury in soil, sediment and gold mining residues was developed, optimized and applied to 30 real samples. It is semiquantitative, performed using an acid extraction pretreatment step, followed by mercury reduction and collection in a detecting paper containing cuprous iodide. A complex is formed with characteristic color whose intensity is proportional to mercury concentration in the original sample. The results are reported as range of concentration and the minimum detectable is 100 ng/g. Method quality assurance was performed by comparing results obtained using the alternative method and the Cold Vapor Atomic Absorption Spectrometry techniques. The average results from duplicate analysis by CVAAS were 100% coincident with alternative method results. The method is applicable for screening tests and can be used in regions where a preliminary diagnosis is necessary, at programs of environmental surveillance or by scientists interested in investigating mercury geochemistry.

Determination of total chromium traces in tannery effluents by electrothermal atomic absorption spectrometry, flame atomic absorption spectrometry and UV-visible spectrophotometric methods.

Three different analytical methods comprising colorimetric method with 1,5-diphenyl-carbazide, electrothermal atomic absorption spectrometry (ET AAS) and flame atomic absorption spectrometry were utilized in a study to determine traces of chromium (Cr) in synthetic tannery effluent from laboratory scale treatment process variations. All the results obtained using the three different methods showed good agreement and met the requirement of Brazilian regulation for total Cr for effluent discharges (<0.5 mg l(-1)). However, ET AAS has been the proposed method because it was faster, less laborious, needed smaller volume of sample and presented lower limit of quantification (LOQ=2.2 mug l(-1)).

A low-cost non instrumental method for semiquantitative determination of mercury in fish.

A non instrumental method for the semiquantitative determination of mercury in fish is described. The sample is acid digested and the mercury vapor released after chemical reduction with SnCl2. The mercury vapor is then collected on a detecting paper covered with an emulsion of Cu2I2, 3% carboxymethylcellulose and MgCl2 as moistener agent. The colored Cu2[HgI4] complex is formed and the color intensity is proportional to the mercury concentration in the original sample. Parameters such as sample mass/digestion solution volume ratio, emulsion composition, paper covering technique, carrier gas flow were investigated. Comparative studies using CVAAS and digital color analysis after scanning the papers confirmed the applicability of the method to real samples.